Howe Mod Heavy
Posted: Wed Dec 04, 2013 1:46 pm
I figured since im going to be putting some work into the Howe Mod I should at least post some of it and get some feedback. Here is my list of things to do this winter.
-Fix holes in exhaust - still needs to be done
-Sand and repaint rust spots - Making Progress
-New Right upper A-arm (Okemo crash) - Done
-Replace oil accumulator (Philo crash) - Done
-New brakes, at least in the front - Done
-Check valve lash - Needs to be done, if I could just find that piece of paper..........
-Remove oil pan and check oil pump
-Rewire trailer winch
-Straighten/modify bodywork (downforce?) - Its straighter......ish
-Mount new tires on rims - Done
-Replace rear axle seals - Wasnt the axle seals leaking
-Check weight distribution
-Change Oil - On the list still
-Open Diff rear end (still on the fence on this one) - Have Diff, will install
-Sway bar (maybe) - Maybe next year.......
-Send redundant ignition box to Crane for repair - Still trying to figure out if they still have a repair service
I still have to finish closing in my shop so that it will hold heat before I can get too far into this list. It may take me a while... - Mostly done, just one sliding door to make
-Fix holes in exhaust - still needs to be done
-Sand and repaint rust spots - Making Progress
-New Right upper A-arm (Okemo crash) - Done
-Replace oil accumulator (Philo crash) - Done
-New brakes, at least in the front - Done
-Check valve lash - Needs to be done, if I could just find that piece of paper..........
-Remove oil pan and check oil pump
-Rewire trailer winch
-Straighten/modify bodywork (downforce?) - Its straighter......ish
-Mount new tires on rims - Done
-Replace rear axle seals - Wasnt the axle seals leaking
-Check weight distribution
-Change Oil - On the list still
-Open Diff rear end (still on the fence on this one) - Have Diff, will install
-Sway bar (maybe) - Maybe next year.......
-Send redundant ignition box to Crane for repair - Still trying to figure out if they still have a repair service
I still have to finish closing in my shop so that it will hold heat before I can get too far into this list. It may take me a while... - Mostly done, just one sliding door to make