Hello hill climb folk. I have been restoring my Formula 3 car and will shortly begin to put it all back together when frame comes back from the shop. I will need a set of custom headers made, and the car will have to go to the shop that does the work as it is a tight fit under the engine cover. So I am hopeful to find someone near to VT? Any suggestions?
Eric
Custom headers
-
Rabbit Farmer
- Posts: 2271
- Joined: Wed Jun 25, 2003 11:37 pm
- AntiSpam: No
- Location: Earth
- Contact:
Re: Custom headers
Joey at KalesCustom.com
They are building a new site, so there is no information there.
Shop phone number is 802-448-3790
Steve
They are building a new site, so there is no information there.
Shop phone number is 802-448-3790
Steve
Go Fast VW & Audi parts at FastAddiction.com
-
Mopar 151w2
- Posts: 342
- Joined: Fri May 11, 2012 9:08 pm
- AntiSpam: No
Re: Custom headers
Jim/Cyrus House may be able to help out
Jason Orzell may also have a good connection - and his connection (Mitch Robinson) may be able to do the aluminum spray coating that was used on GT-40 and many other high-end headers in the 60's and 70's
Design (tube length/dia, collector dimensions, flanges, component sourcing) help, I can definitely do.
Jason Orzell may also have a good connection - and his connection (Mitch Robinson) may be able to do the aluminum spray coating that was used on GT-40 and many other high-end headers in the 60's and 70's
Design (tube length/dia, collector dimensions, flanges, component sourcing) help, I can definitely do.
